Press Fit Calculator
Estimate interference, contact pressure, press force, and thermal assembly clearance for shaft and hub fits.
| Check | Value | Meaning |
|---|
Capable calculator is interactive resource for estimate the interference between hole and shaft. They help to reach apt assembly and tightness in mechanical parts. This utility estimates #various magnitude, for example calculator skill, surface pressure, assembly force and ringan tension.
By means of Lame-equations you do precise analytical of the skill. Some calculators even estimate the needed heat or cold for the temperature and Von Mises-tensions for shaft and hub.
How to Calculate Press Fit Between Hole and Shaft
For use the calculations, several pieces are required. The computation requires internal and external diameter of all involved parts. You must know module of hub and shaft, length of the engagement and good rating of the friction.
Material properties matter, because different materials have a lot different modules. It is also seriously know, whether are surface treatments on the bits, where happen calculator skill, as anodize either whether you uses some lubricant. This can have genuinely big impact on the friction.
Different frotaj coefficients use according to the kind of skill. For calculator skill one takes 0.10. When shrink fits, the value manifests 0.125.
If calculator skill serves for hand over torque, the involved surface ends must calcualte. You do that according to pressure based on frota coefficient between materials.
Dimensions adjust according to the material. For steel, calculator skill can be -0.001 each 1/4-inch diameter. For aluminum or brass, you adds 1 thou to that value.
For more lightweight press with aluminum rod, skill around 0.02-0.04 mm eases assembly. Some strict tolerances go until 0.005 mm. For 1/4-inch steely shaft one thou press is very strict.
Here heat the hole and freeze the shaft by means of CO2-aerosol helps the assembly. Intruda skill wants to say, that hole is less big than the pin.
Pressing shaft in internal race, you must back its orientation by means of the race self. Combination of rings and steely blocks well help. Do not back the orientation of exterior race during pressure in internal.
If calculator skill is for long cylindringo-pin, the involved force must komparigi with kolapsŝarĝo, for ensure, that pin do not crash.
